Tread; Wear Limit - SSANGYONG Actyon Sports II 2012.01 Manual

2) Typical Inspection
- Higher than recommended pressure can cause hard ride, tire bruising or damage and rapid
tread wear at the center of the tire.
- Excessive tire wear over the limit of the tread wear (1.6 mm) can cause lower sliding friction
due to longer braking distance, easy tire burst by foreign materials, tire hydroplaning, and
tough brake and steering wheel handling.
1.

Tread

Inspect the tread condition on the tire
surface and various damages resulting
from the foreign materials, crack, stone or
nail etc. If there is any damage in the tire,
repair or replace it.
2.

Wear limit

- Measure the depth of the tire tread. If
the depth of the tread is below the
specified value, replace the tire
Wear limit
- You can see the protruded part in the
groove at the point with mark "▲", which
is the indicator of the tread wear limit.
- The limit of the tread wear for all season
tires are 1.6 mm, which is the same as
the general tires, but the wear limit mark
is indicated as '↓'.
13-7
4170-09
1.6 mm