Table of Contents
Advertisement
38
AW T 2 1 0 | 2 - W I R E C O N D U C T I V I T Y, P H/O R P, P I O N T R A N S M I T T E R | O I/A W T 2 1 0 - E N R E V. C
...11 Configuration
... Sensor Setup
Toroidal conductivity
Menu
Sensor Setup
Exit
Select
Menu
Comment
Measurement Type
Selects a measurement type compatible with the connected sensor:
Conductivity/Concentration
Conc . Solution
Enabled only if Measurement Type = Concentration.
0-15% NaOH/0-20% NaCl/0-18% HCl/0-20% H2SO4/User Defined
Conc . Unit
Sets the process value units.
Enabled only if Measurement Type = Concentration.
%/ppm/ppb/µg/l/mg/l
Conductivity Unit
Enabled only if Measurement Type = Conductivity.
Auto/µS/cm/mS/cm
Conc . Curve Name
Enabled only if Measurement Type = Concentration.
Conc . Curve Table
Enabled only if Measurement Type = Concentration.
X1 Cond/Y1 Conc/X2 Cond/Y2 Conc/X3 Cond/Y3 Conc/
X4 Cond/Y4 Conc/X5 Cond/Y5 Conc/X6 Cond/Y6 Conc/Table Error
None
Not Saved
Temp . Unit
Temperature unit displayed and applied to all temperature parameters/values.
°F/°C
Temp . Comp . Type
Manual/Auto
Manual Temp .
Enabled only if Temp. Comp. Type = Manual.
Auto TC Option
Enabled only if Temp. Comp. Type = Auto.
Standard KCl/TC Coeff./NaOH/NaCl/HCl/H2SO4/User Def. TC
TC Coeff .
Enabled only if Temp. Comp. Type = Auto and Auto TC Option = TC Coeff.
User Def . TC Curve
Enabled only if Temp. Comp. Type = Auto and Auto TC Option = User Def. TC.
X1 Temp/Y1 K/Kref/X2 Temp/Y2 K/Kref/X3 Temp/Y3 K/Kref/
X4 Temp/Y4 K/Kref/X5 Temp/Y5 K/Kref/X6 Temp/Y6 K/Kref/Table Error
None
Not Saved
Reference Temp .
Temp . Sensor Type
Read-only.
3K Balco 2-wire/3K Balco 3-wire/PT 100 2-wire/PT 100 3-wire/PT 1000 2-wire/PT 1000 3-wire/None
Detect TC Type
TC Detection Status
Read Only/Not Recognized/Recognized
Used to access standard setup parameters.
Note. Sensor Setup menus are sensor-specific – the menus in this section are applicable to
transmitters connected to toroidal conductivity sensor types.
Default
Advertisement
Table of Contents
