Emerson Fisher FIELDVUE DVC6005 Series Quick Start Manual page 10

DVC6005 Digital Valve Controllers
March 2018
Refer to figures 6, 7, and 8 for parts locations. Refer to the following guidelines when mounting on sliding‐stem
actuators with 4 to 24 inches of travel or on rotary actuators:
1. Isolate the control valve from the process line pressure and release pressure from both sides of the valve body. Shut
off all pressure lines to the pneumatic actuator, releasing all pressure from the actuator. Use lock‐out procedures to
be sure that the above measures stay in effect while working on the equipment.
2. If a cam is not already installed on the actuator, install the cam as described in the instructions included with the
mounting kit. For sliding‐stem actuators, the cam is installed on the stem connector.
Figure 7. FIELDVUE DVC6025 Remote Feedback Unit Mounted on Rotary Actuators
CAM
X0915
MACHINE SCREW
TYPICAL MOUNTING WITH SHORT FEEDBACK ARM
(FISHER 1052 SIZE 33 ACTUATOR SHOWN)
Figure 8. FIELDVUE DVC6025 Remote Feedback Unit with Long Feedback Arm and Follower Arm Extension Mounted
on a Rotary Actuator
X0912
10
MOUNTING ADAPTOR
CAP SCREW, HEX SOCKET
FOLLOWER ARM EXTENSION
MACHINE SCREW,
LOCK WASHER,
HEX NUT
CAP SCREW, HEX SOCKET
CAP SCREW
CAM
CAM
X0911
TYPICAL MOUNTING WITH LONG FEEDBACK ARM
(FISHER 1061 SIZE 30-68 ACTUATOR SHOWN)
Quick Start Guide
D103784X012
MACHINE SCREW
CAP SCREW,
HEX SOCKET