Toshiba B-EX Series Key Operation Specification page 92

Initial values when turning the power on
ISSUE COUNT
PRINT SPEED
SENSOR
ＰＲＴ ＴＹＰＥ
TYPE
LABEL LEN.
PAPER
Supplementary explanation:
・ Each fine adjustment parameter is effective for test print. However, the X-coordinate fine adjustment is
excluded.
・ When an error occurs during a test print, the error message is displayed and printing is stopped. The
error LED turns on and the online LED turns off.
・ The error is cleared by a depression of the [CANCEL] key or [ENTER] key, and the display returns to the
test print menu. The error LED turns off and the online LED turns on. Printing is not automatically
resumed after the error is cleared.
・ The label size greater than the image buffer length cannot be designated. If it is designated, the printer
prints data corresponding to the image buffer length then stops, or the printer stops because of an error.
・ When the transmissive sensor is selected, the gap between labels shall be 3 mm.
For the B-EX4, the rotary cutter does not support the print speed of 10 ips or faster. When the rotary cutter is
mounted (regardless of the cut issue is specified), the print speed is corrected to 8 ips even if 10 ips is
selected.
For B-EX4T1-G, specifying less than 15.0-mm pitch label for 3 ips print speed or less than 30.0-mm pitch label
for 6 ips, printing is performed without cut.
For B-EX4T1-T, specifying less than 15.0-mm pitch label for 3 ips print speed, less than 25.0-mm pitch label
for 5 ips, or less than 38.0-mm pitch label for 8 ips, printing is performed without cut.
.
1 piece
203 dpi: 6"/sec.
300 dpi/305 dpi: 5"/sec.
600 dpi: 3"/sec.
Transmissive sensor
Thermal transfer
Batch issue
76 mm
Enabled
87