Cut Adj - Toshiba B-EX Series Key Operation Specification

8.5.2 CUT ADJ

Max. Min. value
value
50.0 -50.0
[Procedure for label having label pitch of less than 25.4 mm when the disc cutter is used]
The minimum label pitch of the label which can be cut in normal use is 25.4 mm. When a label
having a label pitch of less than 25.4 mm is used (although it is out of specifications), the edge of the
label is caught by the edge of the thermal head during a back feed to the home position after cutting
the gap area between labels.
position. By performing either method below, the problem will be solved.
[Method 1] Lift the head.
When the following conditions are all met, the cut operation is as follows.
Head lifted → Forward feed to the cut position → Head lowered → Cut →
Head lifted → Reverse feed to the home position → Head lowered
Conditions: Issue Command, Feed Command, and Eject Command received.
* The head is lifted/lowered only when the optional ribbon saving module is mounted
Step Display
0.1 Decimal
+0.0 mm
+3.0 mm
-3.0 mm
Paper feed direction
Therefore, the label may not be fed back to the proper home
Label pitch of 25.4 mm or less, cut performed, transmissive sensor
designated, cut position fine adjustment of ±10.0 mm or less, and issue
mode "C"
and the ribbon saving function is set to ON with the parameter setting menu. When
the ribbon saving module is not installed, use Method 2 since the print head is not
lifted/lowered.
Sign Integer
digit
Exist 2
76
Decimal 0-padding
place
1 None
Cut position
Cut position
Cut position
Unit of
measure
mm