Icon - Toshiba B-EX Series Key Operation Specification

6.4.2 Icon

Five kinds of icon are displayed in the bottom line of the online mode display.
These icons are displayed only in the online mode display.
Icon
Wireless LAN icon
Link icon
Data transmission icon
RFID icon
Ribbon near end icon
(*4) Icon blinks at 1-second interval (ON for 500 msec. and OFF for 500 msec.)
Explanation
Displayed and used when the wireless LAN module is mounted.
The graph shows the strength of radio wave.
Graph 0: Outside the communication range
Graph 1: Strength of radio wave is weak.
Graph 2: Strength of radio wave is middle
Graph 3: Strength of radio wave is strong
Displayed and used when the wireless LAN module is mounted.
Displayed while the printer is communicating by wireless LAN.
Blinks while roaming.
OFF: No connection
ON: Connecting to an access point
Blink: Roaming (*4)
Appears when a print job is present.
ON: Print job is present.
Displayed and used when the RFID module is mounted.
Appears when a communication between the printer and the RFID
module is enabled.
Blinks during a communication with the RFID module.
- The communication includes the one without radio wave output.
- Blinks after radio wave output is instructed to the module even when no
radio wave is output.
(Blinks while the module stops outputting radio wave or changing the
channel under the influence of other carrier.)
ON: Module type is set and ready to communicate
⇔
Blink: Communicating
Ribbon near end is detected.
Blinks when the ribbon is close to the end.
Ribbon near end is detected depending on the diameter of unused
ribbon. ∅38 mm is equivalent to 30-meter ribbon and ∅43 mm is
equivalent to 70-meter ribbon.
Blinking: Ribbon near end state (*4)
8