Toshiba B-EX Series Key Operation Specification page 89

• The printer is controlled by the sum of the fine adjustment parameter programmed on the printer and the
fine adjustment command from the PC. However, the maximum values for each fine adjustment are as
follows:
Feed fine adjustment ....................................................................... ±50.0 mm
Strip position fine adjustment .......................................................... ±50.0 mm
Back feed fine adjustment ................................................................. ±9.9 mm
Print density fine adjustment ........................................... -20 step to ±10 step
X-coordinate fine adjustment........................................................... ±99.5 mm
Ribbon motor drive voltage fine adjustment (Take-up) ........... -15 to +10 step
Ribbon motor drive voltage fine adjustment (Back tension).... -15 to +10 step
• The X-coordinate fine adjustment is performed to fine adjust the X-coordinate of the drawing in the left or
right direction. Adjust the X-coordinate in the effective print range.
coordinate "0", the value remains unchanged even if a subsequent fine adjustment is performed in the
negative direction.)
• The X-coordinate fine adjustment is not effective for the self-test results printout (maintenance counter,
various parameters, and automatic self-test) and the test print.
• The print density fine adjustment value is +0 step at the time of shipment from the factory.
• The ribbon take-up/back tension motors drive voltage fine adjustment values are the sum of the fine
adjustment by the command (from the PC) and the fine adjustment in the system mode (by key
operation). The maximum fine adjustment values are -15 for both the ribbon take-up motor and the
ribbon back tension motor.
• The print density fine adjustment value is the sum of the fine adjustment by command (from the PC) and
the fine adjustment in the system mode (by key operation). The respective max. Fine adjustment values
are –20 to +10. The max value for each print speed is as below. When the value exceeds the
maximum, it is automatically corrected to the max value.
Speed
3 ips
5 ips
6 ips
8 ips
10 ips
12 ips
14 ips
B-EX4T1-G
Direct thermal Thermal transfer
+10 step
+10 step
+10 step
+10 step
+10 step
Direct thermal
+10 step +10 step
+10 step
+10 step
+10 step
+10 step +10 step
+10 step +10 step
+10 step +10 step
84
(After the value reaches the
B-EX4T1-T
Thermal transfer
+10 step
+10 step
+10 step
+10 step
+10 step
+10 step