Toshiba B-EX Series Key Operation Specification page 67

8.4.1.1 MEDIA LOAD
This function is enabled only when the sensor type is set to other than "None".
・ OFF Media loading function is disabled (Same as feed by depression of the [FEED] key)
When the [FEED] key is pressed after the printer is tuned on, reset in batch mode,
・ STD
or the print head is closed, the printer detects the next gap/black mark and feeds
the paper from the sensor to the print start position .
When the [FEED] key is pressed after the printer is tuned on, reset in batch mode,
・ ECO
or the print head is closed, the printer detects the next gap/black mark and feeds
the paper to the print start position based on the last label pitch printed.
・ ECO+Bfeed After performing the ECO function the printer feeds the paper backward for the
label pitch length while raising the print head if the specified conditions are satisfied.
(See the following conditions.)
8.4.1.2 FORWARD WAIT
Disables the auto forward feed wait
・ OFF
・ ON Enables the auto forward feed wait
8.4.1.3 FORWARD WAIT POS.
Max. Min. value
value
5.0 -5.0
・ + (Plus) Increases the forward feed amount.
・ - (Minus) Decreases the forward feed amount.
NOTES:
1. If the pitch of the media used for the previous issue was less than 20mm, the forward wait will not be
activated regardless of the parameter setting
<Supplement> In the case labels with the different pitch (less than 20mm and 20mm or longer) are
alternately placed in one label roll, the forward wait is not activated for the labels with the pitch of less
than 20mm. Therefore it stays at the print stop position without being fed backward. Before the next label
with the pitch of 20mm or larger is printed, however, it is automatically fed backward along with the
previously printed label. This may cause the print data to be printed on the previous label.
2. The media will stay at the forwarded position even if the power is turned off/on, the printer is reset, or the
print head is opened/closed.
Hardware Optional ribbon saving module (solenoid) is installed.
Parameter RBN SAVE parameter is set to TAG or LABEL
Operation Media pitch falls between 20mm and 100mm.
The previous issue mode was Batch. (The issue mode is not
reset by power off or a printer reset.)
Caution Even if the hardware requirement is not satisfied (the optional
ribbon saving module is not installed), the printer feeds the media
backward when the other requirements are satisfied. However,
this operation is not guaranteed as it is outside of the
specification.
Step Display
0.1 Decimal
Sign Integer
digit
Exist 2
62
Decimal 0-padding
place
1 None
Unit of
measure
mm