Toshiba B-EX Series Key Operation Specification page 48

<< ADJUST >>
Item
[PC] FEED
CUT
BACK
TONE (T)
TONE (D)
RBN (FW)
RBN (BK)
[KEY] FEED
CUT
BACK
TONE (T)
TONE (D)
RBN (FW)
RBN (BK)
X ADJ.
THRESHOLD<R>
THRESHOLD<T>
(*1) For B-EX4T1-G, the print head density is 8 dots/m. The printer behavior is the same regardless of whether
the value is set to "x.2 mm" or "x.3 mm." Therefore, "x.3mm" is printed on the maintenance counter printout
even if "x.2 mm" is set. Similarly, when "x.7 mm" is set, "x.8 mm" is printed on the maintenance counter printout.
Description
Feed amount fine adjustment
Cut position (or strip position) fine
adjustment
Back feed fine adjustment
Print density fine adjustment
(Thermal transfer print mode)
Print density fine adjustment
(Direct thermal print mode)
Ribbon motor drive voltage fine
adjustment (Take-up)
Ribbon motor drive voltage fine
adjustment (Back tension)
Feed amount fine adjustment
Cut position (or strip position) fine
adjustment
Back feed fine adjustment
Print density fine adjustment
(Thermal transfer print mode)
Print density fine adjustment
(Direct thermal print mode)
Ribbon motor drive voltage fine
adjustment (Take-up)
Ribbon motor drive voltage fine
adjustment (Back tension)
X-coordinate fine adjustment
Threshold fine adjustment for
reflective sensor
Threshold fine adjustment for
transmissive sensor
-50.0mm to +50.0mm (*1)
-50.0mm to +50.0mm (*1)
-9.9mm to +9.9mm (*1)
-10 to +10 step
-10 to +10 step
-15 to +10 step
-15 to +10 step
-50.0mm to +50.0mm
-50.0mm to +50.0mm
-9.9mm to +9.9mm
-20 to +10 step
-20 to +10 step
-15 to +10 step
-15 to +10 step
-99.5mm to +99.5mm
0.0V to 4.0V
0.0V to 4.0V
43
Remarks