Hauling The Machine; Towing The Sprayer - Toro Multi Pro 5800-D Operator's Manual

Note:
Most propylene glycol RV antifreeze is
colored pink. Use the catch container to sample
the sprayer discharge at several of the nozzles.
5. Shut off the master section switch, 3 section
switches, agitation switch, spray-pump switch,
and engine.

Hauling the Machine

Use a trailer or truck when moving the machine long
distances.
•
Use full-width ramps for loading the machine onto
a trailer or truck.
•
Tie outer spray sections to the boom-section
transport cradles.
•
Bind the machine securely to the transport vehicle;
Figure 50 and Figure 51
points of the machine.
Figure 50
1. Front tie-down points (front axle)
Figure 51
1. Rear tie-down loops (rear axle tube)
illustrate the tie-down
g239411
g239412

Towing the Sprayer

In case of an emergency, the sprayer can be towed
for a short distance after you open the tow valve.
However, we do not recommend this as a standard
procedure.
WARNING
Towing at excessive speeds could cause a
loss of steering control, resulting in personal
injury.
Never tow the sprayer at faster than 4.8 kph
(3 mph).
Towing the sprayer is a 2-person job. If the machine
must be moved a considerable distance, transport
it on a truck or trailer; refer to
(page 44).
1. Allow the exhaust system to cool completely.
2. Remove the undercarriage shroud; refer to
Removing the Undercarriage Shroud (page
3. Rotate the tow valve
direction to open the tow valve.
1. Tow valve
Important:
If you do not open the tow valve
before towing the sprayer, you will damage
the transmission.
4. Affix a tow line to the frame; refer to the front and
rear towing points
44
Hauling the Machine
(Figure 52) 90° in either
Figure 52
(Figure 53 and Figure
51).
g187500
54).