Error Message; Lcd Models - Brother DCP-7090 Service Manual

3.2 Error Message

The error messages displayed on the LCD of the machine and their description are shown in
the table below.

3.2.1 LCD models

Initial display
Cannot Detect Put the Drum Unit
Cartridge
Error
Connect the
line cord to
LINE socket
on the
machine, and
then set line
type from
Initial Setup in
menu.
Connected the
line cord?
Cooling Down Wait for a while
Cover is Open Close the ADF
Error message
Scroll
back in.
Put the Toner
Cartridge back in.
Put the Toner
Cartridge back in.
▲ Cancel
▲ Done ▼ Later
Cover.
Close the Front
Cover.
Close the Fuser
Cover which can be
found behind the
Back Cover of the
machine.
Description
New process sensor could not
detect the new drum unit
correctly.
Toner cartridge is not
recognized by the cartridge
sensor.
The new toner sensor of the
toner cartridge could not detect
a new cartridge properly.
New toner box sensor could not
detect the new toner box
correctly.
Completed auto-detect as line
cord remained connected to the
external terminal.
Auto-detect ended without
detecting the line voltage.
The side thermistor detected a
temperature higher than the
specified value.
The ADF cover sensor detected
that the ADF cover was open.
The front cover sensor detected
that the front cover was open.
The eject sensor detected that
the fuser cover was open.
2-25
Error Refer
codes to:
4F05 2-53
2400 2-51
4F01 2-53
5E00 2-53
--- 4.13.3
--- 4.13.3
6801 2-57
A400 2-66
6001 2-54
6004 2-54
Confidential