Brother DCP-7090 Service Manual page 66

Error message
Initial display
Document Clear the scanner
Jam jam, then press the
Stop Key.
Drum ! Slide the Green tab
on Drum Unit.
Drum End -
Soon
Ignore Data -
Jam 2-sided Pull out the 2-sided
Tray at the back of
the machine and
remove the jammed
paper.
Jam Inside Open the Front
Cover, pull out the
Drum Unit
completely and
remove the jammed
paper.
Jam MP Tray Remove the
jammed paper from
MP Tray and press
Go.
Jam Rear Open the Back
Cover and remove
the jammed paper,
then press Go.
Jam Tray 1 Remove the
jammed paper from
Tray 1.
Scroll
The document scanning
position sensor detected that
the document length was 90 cm
or more during the one-side
scanning.
The document scanning
position sensor has not
detected the document passing
even after the document has
been fed for the specified time.
Electric discharge that may be
caused by dirt on the corona
wire of the drum unit was
detected.
Number of the drum unit
rotations reaches the upper limit
soon.
Detected undecodable data
during printing.
Received undecodable PS data.
After the first side is printed in 2-
sided printing mode, the
registration front sensor does
not detect paper pass after a set
period of time.
After the registration rear sensor
detects paper pass, the eject
sensor does not detect paper
pass.
When the paper is fed from the
MP tray, after the MP paper
empty sensor detects paper
pass, the registration rear
sensor does not detect paper
pass after a set period of time.
After the registration rear sensor
detects the end of paper pass
and the specified period of time
has passed, the eject sensor
continues to detect paper pass.
When printing from the paper
tray, the registration front sensor
does not detect paper pass
within the specified time after
the T1 paper feed sensor
detected paper pass.
2-26
Description
Error Refer
codes to:
A200 2-65
A300 2-65
6A00 2-58
4000 2-52
--- 4.14.1
7800 2-60
7000 2-58
7200 2-59
7100 2-59
7302 2-60
Confidential