T1 Clutch / Registration Clutch - Brother DCP-7090 Service Manual

9.29 T1 clutch / Registration clutch

 Manual feed models
(1) Release the T1 clutch harness and the Registration clutch harness from the securing
fixtures.
(2) Release the Hook, and remove the T1 clutch.
(3) Release the Hook, and remove the Registration clutch.
<Upper side of Frame L>
Harness routing: Refer to
Assembling Note:
• When securing the T1 clutch harness and the Registration clutch harness, check that
there is no harness slack.
• Attach the Rotation stoppers of the T1 clutch and the Registration clutch by engaging
them with the Pins of the machine as shown in the figure below.
Rotation stopper
Registration clutch
Registration clutch
Registration
clutch harness
Fig. 3-84
"10. Frame L unit (Manual feed
Pin Pin
Fig. 3-85
3-87
Hook
Hook
T1 clutch
T1 clutch harness
<Front side>
models)".
Rotation stopper
T1 clutch
Confidential