Brother DCP-7090 Service Manual page 68

Error message
Initial display
No Paper T1 Reload paper in
Tray 1.
-
No Toner Open the Front
Cover, then install
Toner Cartridge.
Out of Memory Press Stop Key
Paper Low T1 -
Print Data Full Print Data is full.
Press Cancel and
delete the
previously stored
data.
Print Unable Turn the power off
01 and then back on
again.
Print Unable Turn the power off
02 and then back on
again.
Print Unable Turn the power off
03 and then back on
again.
Print Unable Turn the power off
04 and then back on
again.
Scroll
When paper was fed from the
paper tray, the T1 paper empty
sensor or T1 paper feed sensor
detected that no paper was in
the paper tray.
When paper was fed from the
paper tray, the T1 paper empty
sensor or T1 paper feed sensor
detected that no paper was in
the paper tray.
(At Fax / List printing)
When paper was fed from the
paper tray, the engine status
detected that no paper was in
the paper tray.
The new toner sensor detected
that no toner cartridge was set.
The new toner box sensor
detected that no toner box was
set.
The memory is insufficient to
expand the data of PC-Print.
Detected that the paper is
running out when the paper
feed motor drive and T1 paper
empty sensor turned ON.
The memory used to store
secure print data exceeded the
memory size for secure print
data.
ASIC error or motor driver error
occurred.
Cannot detect the synchronized
signal of the paper feed motor.
The speed of the paper feed
motor does not stabilize within
the specified time.
Cannot detect the lock signal of
the polygon motor for the laser
unit. (second time)
BD sensor failure (second time)
2-28
Description
Error Refer
codes to:
9302 2-63
--- 4.2.1
--- 4.2.1
6101 2-55
6106 2-55
C700 2-70
--- 4.14.3
C800 2-70
0102 2-47
0201 2-47
0300 2-47
0401 2-48
Confidential