Table of Contents
Advertisement
UK
Settings and adjustment
Stone protection
Quick-Push shear bolt
When the shear bolt is broken and the tine has been released, place the shear bolt one notch forward
before the machine can operate again.
Pull out the R-clip (Pos. 1).
Pull the tine back to normal working position (Pos. 2).
Push the shear bolt (Pos. 3) one notch forward to a new position in the
tine. Do not push the bolt totally through
(it can be necessary to remove soil etc. from the hole in the tine).
Important: All activities under the machine are deprecated when the
shear bolt is being moved or changed.
Push back the R-clip (Pos. 1), so that it locks the shear bolt in its place,
and the machine is ready for operation.
When the shear bolt is broken for the eighth time, it is used up.
Be aware that the shear bolt must never be shorter than 65 mm.
When a new shear bolt is mounted it is important that it is placed rightly.
The end of 40 mm (Pos. 3) is to turn away from the tine.
It is important to use original
Item no. 645000059,
Yellow chromatised. Calculated for 25 mm tine/leg
Item no. 645000925,
Bright/blue chromatised. Calculated for 15 mm tine/leg
otherwise the machine can be damaged
and our guarantee obligations will no longer apply.
Combi-Tiller MK II
shear bolts,
9
30/04-2019
3
1
2
Back to the table of contents
Advertisement
Table of Contents
