Table of Contents
Advertisement
5-5-4 Connecting Line Input Audio Equipment
Connect the audio output connector of the audio equipment that supplies
the line input signal to the AUDIO IN CH-1 or CH-2 connector.
AUDIO IN switch: At the factory setting,
when the audio cable is connected
to either the AUDIO IN CH-1 or CH-2 connector,
the signal input to the AUDIO IN CH-1 or CH-2
connector is automatically selected as the
signal to be recorded. This is true regardless of
the AUDIO IN switch setting. (This is called XLR
connection automatic detection function.)
When the XLR connection automatic detection
function is set to OFF on the VTR MODE 1 page
of the MAINTENANCE menu, set the AUDIO IN
switch corresponding to the channel to which
the audio equipment is connected to REAR.
Line input connection
Chapter 5 Setting Up the Camcorder
Set the LINE/MIC/
+48 V ON switch for the
channel to which the
audio signal source is
connected to LINE.
Audio equipment
AUDIO IN for CH-1
or CH-2
5
5-25
Advertisement
Table of Contents
