Table of Contents
Advertisement
• When the camcorder power is switched off during auto interval
recording
• When you set the POWER switch to OFF, the camcorder will switch
off by itself after the tape has run for a few seconds to record the
picture data stored in the memory.
• If you remove the battery, unplug the DC cable, or cut power to the AC
3
adaptor while auto interval recording, the picture data shot and stored
before recording stops (maximum 5 seconds, 150 frames) will not be
recorded. Do not change the battery during auto interval recording.
• When tape runs out during auto interval recording
Note that the picture data (maximum 5 seconds, 150 frames) shot and
stored before the tape stops is not recorded if the tape runs out and the
camcorder stops.
Setting the manual Interval Rec
To record in manual Interval Rec mode, you need to turn on manual
Interval Rec mode and set the number of frames to be recorded at
shooting (NUMBER OF FRAME).
1
Follow the procedure of steps 1 to 5 in "Setting the auto Interval
Rec" on page 3-27 to select LOOP/INTVAL REC on the
FUNCTION 1 page.
3-38
Chapter 3 Recording and Playback
Advertisement
Table of Contents
