Table of Contents
Advertisement
b) When SDI is selected, connect the VBS/SDI OUT connector to
the SDI IN connector of the monitor.
When VBS is selected, connect the VBS/SDI OUT connector to
the VIDEO IN connector of the monitor.
c) If you connect the TEST OUT connector to the monitor by
setting TEST OUT SELECT to SD, the down converter
automatically operates even if REAR BNC OUT SEL is set to
OFF.
4
d) When no picture is displayed on the monitor with the TEST
OUT connector feeding the monitor, make sure the type of
monitor (HD monitor / NTSC/PAL monitor) and the signal
format of the output signal of the camcorder (1080i / 525i/625i)
match.
e) When the NTSC/PAL viewfinder or NTSC/PAL monitor is
connected, the markers and zebra patterns are not displayed
when CROP is selected.
3
Turn the MENU knob to move the t mark to the item you want to
set, and push MENU knob.
The t mark at the left of the selected item changes to the z mark
and the z mark at the left of the setting changes to the ? mark.
4
Turn the MENU knob to change the desired setting, and push the
MENU knob.
The z mark at the left of the selected item changes to the t mark
and the ? mark at the left of the setting changes to the z mark.
5
To continue the setting of another output signal, repeat steps 3 and
4.
6
To end menu operations, turn the MENU ON/OFF switch to OFF.
4-102
Chapter 4 Adjustments and Settings for Recording
Advertisement
Table of Contents
