Appliance Setup; Fixed Glass Assembly - Quadra-Fire EXCURSION-I Installation Manual

9

Appliance Setup

A. Fixed Glass Assembly
WARNING! Risk of Asphyxiation! Handle fixed glass
assembly with care. Inspect the gasket to ensure it is
undamaged and inspect the glass for cracks, chips or
scratches.
• DO NOT strike, slam or scratch glass.
• DO NOT operate fireplace with glass removed, cracked,
broken or scratched.
• Replace as a complete assembly.
Removing Fixed Glass Assembly
CAUTION! Handle fixed glass assembly with care.
Glass is breakable.
• Avoid striking, scratching or slamming glass
• Avoid abrasive cleaners
• DO NOT clean glass while it is hot
•
The glass assembly fastens to the fireplace in four
places. Four of the fastening mechanisms are spring-
loaded glass latches. An example of the glass latch is
shown in Figure 9.2.
• To release glass assembly, use the supplied multi-
purpose tool to pull the two bottom spring-loaded
latches forward and allow them to retract away from
the glass assembly.
assembly outward until the top latches disengage.
GLASS CLIPS
Figure 9.1 Multi-PurposeTool
Replacing Fixed Glass Assembly
• Tilt the top of the glass assembly toward fireplace and
slide glass assembly upward to engage
top latches. Verify top latches are fully engaged and
then fasten the two bottom latches using the supplied
multi-purpose tool.
• Reinstall door or decorative front.
Quadra-Fire • EXCURSION-I, EXCURSION-II, EXCURSION-III Installation Manual • 2538-980 Rev. E • 5/19
36
Tilt the bottom of the glass
GLASS SEAL PLATE
GLASS SEAL
PLATE INSTALLED
Figure 9.2 Glass Seal Plate
WARNING! Glass seal plate must be properly installed.
Risk of elevated component temps and carbon monoxide
exposure.