Table of Contents
Advertisement
12
12
Appliance Setup
A. Remove Glass Assembly
See Section 12.L.
B. Remove the Shipping Materials
Remove shipping materials from inside or underneath the
fi rebox.
C. Clean the Appliance
Clean/vacuum any sawdust that may have accumulated
inside the fi rebox or underneath in the control cavity.
D. Accessories
Install approved accessories per instructions included
with accessories. Contact your dealer for a list of ap-
proved accessories.
WARNING! Risk of Fire and Electric Shock! Use ONLY
Hearth & Home Technologies-approved optional acces-
sories with this appliance. Using non-listed accessories
could result in a safety hazard and will void the warranty.
E. Door Crown Installation
Open lower access panel. Pull out and unhook the two
spring latches on the bottom of the appliance that secure
the door.
Rotate the door forward approximately 1-1/2 in. (38 mm).
Holding the ashlip, lift the door up off of the stationary
latches and away from the appliance.
STATIONARY LATCHES
STATIONARY LATCHES
SPRING LOADED LATCHES
SPRING LOADED LATCHES
Figure 12.1
Quadra-Fire • HUDBAY-INS • 7008-115 Rev. o • 8/11
Uninstall the existing crown by removing the four screws
on the back side of the door. Retain the screws.
Figure 12.2
Use a fl at-head screwdriver to pry the black crown free on
the right side. Remove the crown and discard.
Figure 12.3
Carefully align the left side of the crown into place, and
wrap it across the face of door, fi nally snapping it into
place on the right hand side. Reinsert and tighten the
screws previously removed.
Figure 12.4
Note: Use a soft cloth and a window cleaning solution to clean
all fi ngerprint oils from the gold or nickel surface of crown
PRIOR to lighting the appliance.
29
Advertisement
Table of Contents
