Checking A Memory Channel's Status; Erasing Memory Channel Data - Yaesu FTDX9000D Operation Manual

M O
EMORY
Before programming a channel into memory, you can check the current contents of that channel without the danger of
over-writing the dama accidentally.
1. Press the MCH/GRP key momentarily. The im-
bedded LED will glow Red, indicating that you are
now ready to view memory channel contents.
Advice
If the Red LED imbedded in the MCH/GRP switch does not
light up, check to be sure that the orange lamp to the right of
the CLAR/VFO-B knob is not illuminated. It it is, press the
A/B switch to make it go out, then press the MCH/GRP
key again.
2. Press the A M key (#
The data stored in the currently-selected memory
channel will be displayed in the Sub (VFO-B) band
frequency field. However, since you are only check-
ing the contents of the memory channel, your radio
will not have moved to the memory channel's fre-
quency.
3. Rotate the CLAR/VFO-B knob to select other
memory channels. To exit from the Memory Check
mode, press the A M key once more.
1. Press the MCH/GRP key momentarily. The imbed-
ded LED will glow Red, indicating that you are now
ready to view memory channel contents.
Advice
H If the Red LED imbedded in the MCH/GRP switch does
not light up, check to be sure that the orange lamp to the right
of the CLAR/VFO-B knob is not illuminated. It it is, press
the A/B switch to make it go out, then press the MCH/
GRP key again.
2. Press the A M key (#
The data stored in the currently-selected memory chan-
nel will be displayed in the Sub (VFO-B) band fre-
quency field.
3. Rotate the CLAR/VFO-B knob (#
memory channel that you would like to erase.
4. Press the LOCK switch (#
of the selected memory channel.
Advice
H After erasure, only the memory channel number will
remain; the frequency data will disappear from the
display.
H If you make a mistake and wish to restore the memory's
contents, just repeat steps (1) through (3) above.
Page 116
PERATION

Checking a Memory Channel's Status

).
E M
RASING EMORY
).
) to select the
) to erase the contents
Advice
H While the Memory Check function is engaged, the
memory channel number will blink.
H While operating in the VFO mode, using Memory
Check, you may store the current contents of the VFO
into the selected memory by pressing and holding in
the A M key for two seconds (until the double
beep). Conversely, if you wish to write the contents
of the current memory into the Main (VFO-A) regis-
ter, press and hold in the M A key (#
seconds.
C D
HANNEL ATA
FT 9000D O
DX
switch
MCH/GRP switch
CLAR/VFO-B knob
) for two
switch LOCK switch
CLAR/VFO-B knob
M
PERATION ANUAL