Setting Of Dip Switch - Hitachi HIDIC EH-150 Applications Manual

5.2.4

Setting of Dip switch

To set Ethernet information by Web browser, set bit 1 ON, bit 2 OFF of dip switch.
In this mode, bit 3 to 8 means lower 6 bit of IP address. Furthermore remained higher 26 bits of IP address
is fixed. Figure 5.2.4.1 shows the temporary IP address.
192.
1 1 0 0 0 0 0 0 1 0 1 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 * * * * * *
Figure 5.2.4.1 Temporary IP address at the time of the Ethernet information setting by a Web browser
As figure 5.2.4.1 shows, the temporary IP address is selected in the range from [192.168.0.1] to
[192.168.0.63].
Table 5.2.4.1 shows the example of DIP switch setting. After setting the dip switch, power PLC on.
Table 5.2.4.1 Dip switch setting (Ethernet information setting mode by Web browser)
Bit No.
1 2 3 4
OFF IP address lowest byte
ON b'000001 to b'111111(1 to 63)
Caution
- IP address "192.168.0.0" is special address. Do not set bit 3 to 8 all OFF at bit 1 ON and 2 OFF of dip switch. In this
condition, when EH-ETH is power on, LED turns as below.
SOFTWARE VER.00 to 02: STATUS LED 6 times a cycle with red a flickering
SOFTWARE VER.03 later: STATUS LED 7 times a cycle with red a flickering, and I.ERR LED turns red.
- IP address set by dip switch is used temporary to access web page of EH-ETH. This setting of dip switch is not stored
to FLASH memory of EH-ETH.
- When you participate EH-ETH to Network of established, be careful to the duplicated IP address.
Chapter 5 Configuration and procedure for starting communication
168.
Higher 26 bit (fixed)
5 6 7 8
Set Ethernet information by Web browser.
5-5
0. 1 to 63
Lower 6 bit
Description