Installing The Software - Siemens SIMATIC FM 452 Manual

Installing the Software

Introduction
You make the required settings for the FM 452 using the Parameter Assignment
User Interface. This user interface is intended for both the FM 452 and the
FM 352. You will find a description of the Parameter Assignment User Interface in
the online help.
Requirements
Before you start to assign parameters for the FM 452 electronic cam controller,
you should check that the following requirements are met:
STEP 7, Version V4.02 or higher is correctly installed on your programming
device/PC.
Installation
The entire software is on the supplied CD. It is installed as follows:
1. Insert the CD in the drive on your programming device/PC.
2. Start the software installation dialog in Windows 95/Windows NT by clicking the
"Add/Remove Programs" icon in the "Control Panel".
3. In this dialog, select the CD drive and the folder FMx52\Disk1, then select the
file Setup.exe and start the installation.
4. Follow the instructions displayed by the installation program.
Result:The software is installed in the following folders:
– SIEMENS\STEP7\S7LIBS\FMx52LIB : FCs and UDTs
– SIEMENS\STEP7\S7FCAM: parameter assignment user interface, readme,
online help
– SIEMENS\STEP7\EXAMPLES\zEn19_01 : example
– SIEMENS\STEP7\MANUAL: manual
Note
If you installed STEP 7 in a folder other than SIEMENS\STEP7, this folder is
entered.
Configuration and Parameter Assignment
These topics are described in Chapter 7.
FM 452 Electronic Cam Controller
C79000-G7076-C452-04
5
5-1