Table of Contents
Advertisement
Layout and Installation
3.2
Hardware- and Software configuration
•
Hardware configuration
−
Programming units PG 730, PG 750, PG 770 or industrial standard PC with at least Intel
80386 or 80486 processor at least 4MB memory and a hard disc with at least a capacity
of 40MB
−
Appropriate cable from PG/PC to WS 720
−
Single axis controller WS720
−
Printer DR210, DR211, DR230, DR231
•
Software configuration
−
MS-DOS 3.3 or higher
−
Microsoft Windows 3.1 or higher
3.3
Installing the COM 720 software
When all hardware and software requirements have been fulfilled, you can load the COM 720
software onto the hard disc of your PG or PC.
•
Find out in which path Windows is installed.
•
Insert the COM 720 disc into the drive and select this drive.
•
Start the installation program with the command INST720.
You will be guided through the installation. If you already have installed the COM 720 software
but wish to re-install, this is no problem. The old settings will be overwritten by the new.
3.4
Installation of SYSDOK 720
The help file com720at.hlp contains all the integrated documentation and is installed
automatically with the COM 720 software.
Siemens Automation Parts
3 - 2
© Siemens AG 1993 All Rights Reserved
WS 720 A (BN - COM 720 description)
10.99
6ZB5 440-0RV02
Advertisement
Table of Contents
