Siemens SIMATIC FM 452 Manual page 205

Interrupt handling, 6-17
INTF, 11-3
J
Job, execute, 6-5
Job management for FC CAM_CTRL, C-7
Job management for FC CAM_MSRM, C-7
Job status, 6-8
JOB_ERR messages, C-13
Jobs, 6-6
L
Lead distance, 8-29
Lead time, 2-10, 8-29
actual, 8-29
calculate, 8-29
LED
"EXTF", 11-3
"INTF", 11-3
LEN_VAL, 9-17
Length measurement, 9-15
data update, 9-16
incorrect, 9-18
minimum, 9-17
requirements, 9-15
result, 9-16
Limit switch, 7-2
relevant for safety, 7-2
Line length, A-4
Linear axis, 1-2, 8-7, 8-8
Linear measure, 8-18
Listen, 8-15
Listen-in, 10-7
wiring, 10-7
Listen-in
frame length / type, range of values, 10-6
increments per encoder revolution, 8-17
Listen-in mode-, 4-3
Loss of synchronization, 9-8
LTIME, 8-29, 9-13
M
Machine and cam data, order when writing, 8-5
FM 452 Electronic Cam Controller
C79000-G7076-C452-04
Machine data, 8-1
absolute encoder adjustment, 8-12
activating, 8-2, 8-3
activation of the track outputs, 8-23
axis, 8-7
axis type, 8-7
baudrate, 8-18
changing, 8-2
count direction, 8-19
distance per encoder revolution, 8-16
enable hardware interrupt: cam on/off, 8-25
enable hardware interrupt: measurement
end, 8-25
enable hardware interrupt: measurement
start, 8-25
enable input, 8-24
encoder type, 8-15
end of rotary axis, 8-7
end software limit switch, 8-9
frame length, 8-15
hysteresis, 8-9
increments per encoder revolution, 8-17
minimum edge-to-edge distance, 8-11
monitoring, 8-19
number of encoder revolutions, 8-18
reading, 8-3
reference point coordinate, 8-8
simulation speed, 8-11
special tracks, 8-24
start software limit switch, 8-9
type of reference point retriggering, 8-8
upper counter value counter cam track,
8-24
writing, 8-2
Machine data error, C-18
Machine data of the encoder, 8-15
data in the parameter DB, 8-15
definition, 8-15
Master mode, 4-3
Maximum cable length, 8-18
MD_EN, 8-3
MDRD_EN, 8-3
MDWR_EN, 8-3
Messages, C-22
Minimum edge-to-edge distance, 8-11
Minimum length measurement, 9-17
Missing pulses, incremental encoder, 8-19
Index
Index-5