Table of Contents
Advertisement
PST Mode
M2 supports 2 HDMI preview output, and it supports the functions as below:
Signal Selection
Push any button in Input Sources Area, for example, push the button [5], the border of signal 5 will change to
yellow, and the signal in PGM monitor will be changed to signal 5.
Add or Delete Layer
Push any button of [A] to [D] in Layer Selection Area to add or delete the layer.
Add layer: The light is lit.
Select layer: The light is flashing.
Delete layer: The light is off.
Freeze the Layer
Push the [FREEZE] button in Layer Adjustment Area, the layer will be freeze, push the button again, the layer is
live.
Multiview Presets
1. Push any button in Multiview Presets Area to select multiview layouts, including 1P, PIP CENT and 3P.
2. User can adjust the position, size for the selected layer, and set DSK, BLEND and MASK.
Set the Position
1. Push any button of [A] to [D] in Layer Selection Area, the light is flashing when the layer is selected.
2. Push the [POS] button in Layer Adjustment Area, and enter to the menus as follows:
Use the rotary knob or joystick to adjust the position of the layer.
When swing the joystick to the left or right, the horizontal position will be changed.
When swing the joystick up or down, the vertical position will be changed.
Scale and Crop the Layer
1. Push any button of [A] to [D] in Layer Selection Area, the light is flashing when the layer is selected.
2. Push the [SCALE] button in Layer Adjustment Area, and enter to the menus as follows:
© Xiamen RGBlink Science & Technology Co., Ltd.
Ph: +86 592 5771197 |
->H Pos
V Pos
Reset
support@rgblink.com
13
|
www.rgblink.com
120
329
>>
13 / 28
Advertisement
Table of Contents
