Genie S-40 Service Manual page 79

Section 3 • Scheduled Maintenance Procedures
CHECKLIST D PROCEDURES
5 Remove the drive hub mounting bolts. Carefully
remove the turntable rotate drive hub assembly
from the machine.
Crushing hazard. The turntable
rotate drive hub assembly could
become unbalanced and fall if not
properly supported by the lifting
device.
6 Remove the plug from the side of the drive hub.
Drain the oil from the hub into a suitable
container.
7 Install the drive hub assembly onto the
machine. Torque the drive hub mounting bolts
to specification. Refer to
Section 2, Specifications.
8 Fill the drive hub with oil from the side hole until
the oil level is even with the bottom of the hole.
Apply pipe thread sealant to the plug. Install the
plug.
3 - 46
D-5
Perform Engine Maintenance -
Deutz and Perkins Models
Engine specifications require that this procedure be
performed every 1000 hours.
Deutz models
Required maintenance procedures and additional
engine information are available in the
Deutz 1011F Operation Manual
( Deutz part number 0297 9683) or the
Deutz 2011 Operation Manual
( Deutz part number 0312 3547).
Deutz 1011F Operation Manual
Genie part number
Deutz 2011 Operation Manual
Genie part number
Perkins models
Required maintenance procedures and additional
engine information are available in the
Perkins 404-22 Operation Manual
(Perkins part number TPD 1443S).
Perkins 404-22 Operation Manual
Genie part number
To access the engine:
Remove the engine tray retaining fasteners
located under the engine tray. Loosen the pivot
fastener located at the platform end of the
engine tray. Swing the engine tray out and
away from the machine and secure it from
moving
S-40 • S-45
October 2013
Crushing hazard. Failure to secure
the engine pivot plate from moving
could result in death or serious
injury
Part No. 102521
52883
139320
94890