Perform Engine Maintenance - Ford Models - Genie S-40 Service Manual

Section 3 • Scheduled Maintenance Procedures
CHECKLIST B PROCEDURES
6 Loosen the tensioner jam nut and idler axle bolts
on both sides of the tensioner wheel and tighten
the tensioner nut until there is between 0.75 - 1
inch /
1.9 - 2.5 cm of gap between the bogey wheels
and the inside surface of the track.
Component damage hazard.
Do not over tighten the track.
Overtightening the track will cause
the machine to lose power during
operation.
7 Tighten the jam nut.
8 Check the torque of the track assembly
fasteners. Refer to Section 2, Specifications .
9 Raise the machine, remove the jack stands and
lower the machine.
10 Repeat this procedure for each track assembly.
3 - 34
B-24
Perform Engine Maintenance -
Ford Models
Engine specifications require that this procedure be
performed every 400 hours.
Proper engine maintenance, following the engine
manufacturer's maintenance schedule, is essential
to good engine performance and service life.
Failure to perform the maintenance procedures
can lead to poor engine performance and
component damage.
Required maintenance procedures and additional
engine information are available in the
Ford LRG-425 EFI Operator Handbook
(Ford part number FPP 194-302) or the
FFord DSG-423 EFI Operator Handbook
(EDI part number 1060020) or the
Ford MSG-425 EFI Operator Handbook
(Ford part number 1020010) .
Ford LRG 425 EFI Operation Manual
Genie part number
Ford DSG 423 EFI Operator Handbook
Genie part number
Ford MSG-425 EFI Operator Handbook
Genie part number
To access the engine:
Remove the engine tray retaining fasteners
located under the engine tray. Loosen the pivot
fastener located at the platform end of the
engine tray. Swing the engine tray out and
away from the machine and secure it from
moving.
S-40 • S-45
October 2013
Crushing hazard. Failure to secure
the engine pivot plate from moving
could result in death or serious
injury.
Part No. 102521
84792
119488
215322