Genie S-40 Service Manual page 35

Section 3 • Scheduled Maintenance Procedures
SCHEDULED MAINTENANCE PROCEDURES
Maintenance Symbols Legend
Note: The following symbols have been used in
this manual to help communicate the intent of the
instructions. When one or more of the symbols
appear at the beginning of a maintenance
procedure, it conveys the meaning below.
Indicates that tools will be required to
perform this procedure.
Indicates that new parts will be required
to perform this procedure.
Indicates that a cold motor, pump or
engine will be required to perform this
procedure.
Indicates that a warm motor or pump
will be required to perform this
procedure.
Indicates that dealer service is required
to perform this procedure.
3 - 2
Pre-delivery Preparation Report
The pre-delivery preparation report contains
checklists for each type of scheduled inspection.
Make copies of the Pre-delivery Preparation
Report to use for each inspection. Store completed
forms as required.
Maintenance Schedule
There are five types of maintenance inspections
that must be performed according to a schedule—
daily, quarterly, every six months, annual and
two years. The Scheduled Maintenance
Procedures Section and the Maintenance
Inspection Report have been divided into five
subsections—A, B, C, D and E. Use the following
chart to determine which group(s) of procedures
are required to perform a scheduled inspection.
Inspection
Daily or every 8 hours
Quarterly or every 250 hours
Six months or every 500 hours
Annual or every 1000 hours
Two years or every 2000 hours
Maintenance Inspection Report
The maintenance inspection report contains
checklists for each type of scheduled inspection.
Make copies of the Maintenance Inspection Report
to use for each inspection. Maintain completed
forms for a minimum of 4 years or in compliance
with employer, jobsite and govermental regulations
and requirements.
S-40 • S-45
October 2013
Checklist
A
A + B
A + B + C
A + B + C + D
A + B + C + D + E
Part No. 102521