Genie S-40 Service Manual page 116

October 2013
Ford LRG-425 EFI models:
1 Disconnect the electrical connector for the
oxygen sensor at the tailpipe. Do not remove
the oxygen sensor.
2 Remove the engine oil dipstick fasteners from
the muffler bracket. Remove the dipstick from
the engine.
3 Remove the muffler retaining fasteners from the
exhaust pipe.
4 Support the muffler and bracket assembly with
an overhead crane or other suitable lifting
device.
5 Remove the muffler bracket mounting fasteners.
Carefully remove the muffler and bracket
assembly from the engine.
6 Support the engine with a suitable lifting device.
Do not lift it.
7 Remove the engine plate to vibration isolator
fasteners.
8 Remove the engine mounting plate to bell
housing fasteners.
9 Raise the engine slightly to take the weight off
of the engine mounting plate.
10 Slide the engine mounting plate towards the
pump as far as it will go.
11 Support the drive pump assembly with an
appropriate lifting device.
Part No. 102521
12 Remove all of the engine bell housing fasteners.
13 Carefully pull the pump and bell housing
assembly away from the engine and secure it
from moving.
14 Remove the flex plate mounting fasteners.
Remove the flex plate from the flywheel.
Ford DSG-423 EFI models:
1 Disconnect the electrical connectors from both
oxygen sensors at the tailpipe and exhaust
manifold. Do not remove the oxygen sensors.
2 Remove the exhaust pipe fasteners at the
muffler.
3 Support the muffler and bracket assembly with a
suitable lifting device.
4 Remove the muffler bracket mounting fasteners
from the bell housing. Carefully remove the
muffler and bracket assembly from the engine.
5 Support the engine with an overhead crane or
other suitable lifting device. Do not lift it.
6 Remove the engine mounting plate to bell
housing fasteners.
7 Raise the engine slightly using the overhead
crane and place a block of wood under the oil
pan for support.
8 Support the drive pump assembly with an
overhead crane or other suitable lifting device.
Do not apply any lifting pressure.
S-40 • S-45
Section 4 • Repair Procedures
Component damage hazard. Hoses
can be damaged if they are kinked
or pinched.
ENGINES
4 - 25