Error messages and troubleshooting
5.2 Error messages
Error code
error_FC
Table 5-3
Error code
5-8
Flashing of
ERR LED
(B#16#..)
1F
–
Error variable "error_FC"
(B#16#..)
00
No error; default value if everything is ok.
01
Params_DB not available in SIMATIC
02
Params_DB too small
UDT 10/11 was not used during definition
•
Params_DB must be 300 bytes in length (for each channel)
•
Check that Params_DB and Params_ADDR are correct
•
03
The DB after the "command_DB_number" pointer is not available in the SIMATIC.
04
"command_DB" in the SIMATIC too small
UDT 20/21 was not used during command definition
•
The last command in "command_DB" is a chained command; reset the chaining
•
bit
Check command pointer command_DB_number/command_DB_address
•
05
Invalid command type. The valid commands are described in Section "MOBY
commands".
Check command pointer command_DB_number/command_DB_address
•
Check the current values in command_DB
•
Execute an init_run
–
06
Unexpected acknowledgement received. The parameters of the command and
acknowledgement telegram do not match (command, length, address_MDS).
The user changed the command_DB_number/_address pointer during command
•
execution.
The user changed the command parameters in the MOBY CMD data block (UDT
•
20) during command execution.
Check the ASM_address and ASM_channel parameter settings. ASM_address
•
and ASM_channel have the same parameters for different channels.
Acknowledgement and command counters (see Section "Cyclic control word
•
between master and MOBY-ASM") between ASM and FC no longer
synchronized
Execute an init_run
–
07
The MOBY_mode or MDS_control parameter (defined in UDT 10) has an illegal
value (see Section "Parameter data block").
08
A bus error has occurred which is reported by system functions SFC 58/59. More
information on this error is available in the error_BUS variable.
ASM_address or ASM_channel not available
•
Execute an init_run
•
Running command canceled by RESET (init_run or cancel) or bus
connector removed
Communication with the MDS was terminated by init_run.
•
This error can only be reported on init_run or cancel
•
Description
Function manual, Release 03/2006 , J31069-D0167-U001-A2-7618
Description
FC 45