Command Parameters; Table 3-11 Next - Siemens SIMATIC FC 45 Function Manual

Parameterizing
3.2 MOBY commands
3.2.1

Command parameters

Overview of commands
Table 3-6
*) Chained commands are not supported by all write/read devices or ASMs. Adhere to the information
in the MOBY manuals for configuration, mounting and service.
Write
Table 3-7
Command
01
*) When UDT 70 is used, "length" is specified as a hexadecimal value. The value range is then from
0001 to FFFF. A complete 64 KB transponder can thus be processed.
Read
Table 3-8
Command
02
*) When UDT 70 is used, "length" is specified as a hexadecimal value. The value range is then from
0001 to FFFF. A complete 64 KB transponder can thus be processed.
3-12
Overview of commands
Command [hex]
normal chained*
01 41
02 42
03 43
04 44
06 –
08 48
0A 4A
0B 4B
Write to MDS
sub_command
[hex] [hex]
–
Read MDS
sub_command
[hex] [hex]
–
Write data to MDS
Read data from MDS
Initialize MDS
SLG status
NEXT
END; conclude communication with the MDS
Antenna on/off
MDS status
length address_MDS
[dec] [hex]
1 to 32767 * 0000 to FFFF
length of the The data are
MDS data to written
be written to the MDS starting
at this start
address.
length address_MDS
[dec] [hex]
1 to 32767 * 0000 to FFFF
length of the The data are read
MDS data to from the MDS
be read starting at this start
address.
Function manual, Release 03/2006 , J31069-D0167-U001-A2-7618
Command
DAT_DB
[dec]
Pointer to the
user data
which are to
be written to
the MDS
DAT_DB
[dec]
Pointer to user
data. FC 45
reads and
stores the
MDS data
here.
Note
Note
FC 45