Table of Contents
Advertisement
NEXT command
The Next command switches ASM control to the next mobile data memory. The Next
command must always be programmed when MDS control is used (MDS_control = 2).
After the ASM acknowledges the Next command, a read/write job for the next MDS can be
sent immediately to the write/read device. The new command waits on the ASM until the old
MDS has left the field and a new one has entered.
This type of programming makes it possible to execute an ASM command as soon as an
MDS enters the field of the write/read device.
It can be very advantageous to add the NEXT command at the end of a command chain
(see Section "Command chaining").
See also
INPUT parameters (Page 3-3)
FC 45
Function manual, Release 03/2006 , J31069-D0167-U001-A2-7618
Parameterizing
3.3 Presence check and MDS control
3-23
Advertisement
Table of Contents
