Appendix E. Waterproofing The Cable Connections - Planet Networking & Communication ICA-E6265 User Manual

2 Mega-pixel IR PoE Plus Speed Dome IP Camera
ICA-E6265
Appendix E. Waterproofing the Cable
Connections
The camera itself is waterproof, however take note that the cable connections are not. If the camera is
mounted directly on the ceiling/wall where the cables pass through the ceiling/wall, then your
installation is complete and you do not need to waterproof the cable connections.
However, if the camera is mounted where the cables may be exposed then it is recommended to
waterproof the cable connections or use a junction box (not included in the package).
The camera comes with a Cable Gland and Conduit Gland. It is recommended to use one of these
glands when a high PoE injector will be used with the camera. However, if the bundled power supply
will be used or digital input/output devices will be connected, it is recommended to house the cables
inside the junction box.
Waterproofing the Cable by Cable Gland
Prepare the following items:
Cable Gland Gland Rubber Ring Exterior-Grade Ethernet Cable Waterproof Tape
(not included in
the package)
(not included in the package)
Detach the cable gland as shown below.
128