Appendix G. Connecting Audio Devices
The camera comes with audio input and output jacks to connect a m icrophone or speaker to the
camera. The audio jacks are covered with a rubber protection. If using an audio input device, such as
a microphone with a built-in amplifier, connect the device to the Audio Input jack (red) of the camera.
If using an audio output device, such as a s peaker, connect the device to the Audio Output jack
(green) jack of the camera.
If the camera is installed outdoors, be sure to wrap the audio connectors with waterproof tape (can be
purchased in local hardware stores).
1.
Make sure that the connected audio input device has a built-in amplifier. Connecting
an ordinary microphone will dwarf sounds and will result in inaudible recording.
2.
If the audio connectors will not be used, leave the rubber caps on to avoid dust from
entering the connectors.
2 Mega-pixel IR PoE Plus Speed Dome IP Camera
137
ICA-E6265