Manual Event - Planet Networking & Communication ICA-E6265 User Manual

2 Mega-pixel IR PoE Plus Speed Dome IP Camera
ICA-E6265
Upload video/snapshots: Select which of the event configurations to include in this response set. If
you are sending email via upload video and sending notification message at the same time, the
system will automatically merge the two emails into one. The subject and image will be based upon the
Upload snapshot Event configuration enabled, but the message in the body text will be based upon the
Notification messages.
In general, please stick to the "one email per event rule" limit for best performance.
Change Motion Detection profile: This will switch the profile of the selected Motion Detection region
from Runtime profile to Event profile. The profile will return to runtime settings at the end of this event.
You may program one m otion detection region to be disabled at runtime, but enable it with event
handler under some circumstances.
Send URL command: Select the URL command to include in the response set. Two different
commands will be sent at the time when the event is triggered and un-triggered. For example, going to
a preset point, if the device is a PTZ camera, and there are preset points already configured in PTZ
setup page, then you may include this in the response section of the event rule by using Send URL
Command method. It is possible to let the camera return to another preset point at the end of the
event.
Change to Day/Night Mode (Selected models only): For some models, you may force the Camera
into Day or Night mode. The camera will return to its previous setting (whether auto or forced day/
night) upon the end of the event.
After changing any of the items above, press Apply to save the changes. The Reset button undoes
the changes that had just been made but not Applied yet.

3.11.4 Manual Event

You may select one event in the Manual Event area below to be triggered via web user interface.
After changing any of the items above, press Apply to save the changes. The Reset button undoes
the changes that had just been made but not Applied yet.
109