Table of Contents
Advertisement
(3)
Once done, click
(4)
Click
of scan point 2 to set the scan ending point.
(5)
Pan and tilt on the area that you want to set as the ending point.
(6)
Once done, click
(7)
Select the preferred Scan Speed.
(8)
Select the preferred Scan Direction: Clockwise or counter-clockwise.
Parameters
Start Scanning
To start scanning, click
Stop Scanning
To stop scanning, click
Restart Scanning
To restart scanning from the starting point while scanning is in progress, click
Return to Auto
When scanning is interrupted by other camera operation, like pan, tilt, zoom, etc.,
Scan after
checking Return to Auto Scan after box enables the camera to resume scan
function after the defined period of time (seconds).
Scan Speed
Scan Direction
Set
To set the position as the point, click
Delete
To delete the scan point, click
If both Tour and Scan Controls are enabled at the same time, Touring Control takes priority
over Scan. Tour must be disabled first to use the Scan function.
3.4.4 Auto Tracking
Auto Tracking captures moving objects within the view and follows the objects as they move around
providing unattended surveillance. In case of opposing moving objects, the camera follows the objects
which are more in focus.
Note that Auto Tracking cannot function at the same time with Touring Control and Scan Control. To
enable Auto Tracking, disable Touring Control or Scan Control first.
2 Mega-pixel IR PoE Plus Speed Dome IP Camera
again to close and complete first scan point.
again to close and complete scan point 2.
.
: The bigger the number, the faster the speed.
: Clockwise
: Anti-clockwise
Description
.
.
.
.
50
ICA-E6265
Advertisement
Table of Contents
