Event List - Planet Networking & Communication ICA-E6265 User Manual

2 Mega-pixel IR PoE Plus Speed Dome IP Camera
ICA-E6265
provides a DI signal to the PTZ camera, and triggers an event. This event then sends a loopback
command to the PTZ Camera itself (by setting its own IP as the HTTP CGI server). The PTZ Camera
then moves to a preset location, stays until the event is over, and then moves back to another location.
At the same time it moves to the pre-set location, it increases the bitrate from 1M to 3M, and the frame
rate from 4 fps to 8 fps. The bitrate / fps changes are reverted at the end of event.

3.11.3 Event List

You may define a maximum of 10 Event rules, which will be shown in the abbreviated form in the Event
List panel. It will display under each Event ID, the days of the week it will be active, the start time and
duration of the active period, the type of the source of trigger, and the actions used in the response. If
the row is grayed out, this means the rule is currently not enabled and stays inactive.
You may start creating a new event by clicking the event ID number in the list, for example "2".
There are several parts to the Event rule:
When is it active?
You may choose to enable the rule or not. The settings will be kept in internal memory even if the event
rule is disabled. Select the days in a weekly cycle in which this rule and schedule is active.
Determine the start time and dur ation of the active period. For example, a rule that lets motion
detection trigger snapshot uploads to FTP would only take place after 19:00 each day for 12 hours.
Outside of this time the rule will not be active.
106