Advertisement
All parts for the inside of the hull should be
ready now. Please varnish them 2 to 3 times
and sand between each application so that
they are water proofed. Also the deck should
be varnished on the underside.
Place the Servo temporarily into the tray and
drill the holes with 1.5 mm drill for the Servo
screws.
Drill
Stand Juli 2014
7. Preparation of the Motor
Solder on the motor the suppression capaci-
tors 103 (10nf) to the connections and to the
motor housing as shown. Sand before solder-
ing, to ensure a good connection for the solder.
Then solder the third capacitor 473 (47 nf)
between the two motor connections. Place
insulation tube on the ends before soldering.
Now solder motor wires to the connections.
Servo
After that you can assemble the motor to the
motor frame.
8. Fitting out the Hull
Push the prop shaft through the hole in the hull
and fit the motor on the motor mount. Now
attach the brass coupling between Motor and
prop shaft with grub screws M3. Please check
that there is a gap of about 1 mm between
motor housing and coupling.
Now align the motor together with motor
mount, prop shaft and tube inside the hull. The
whole setup should be placed in the centred of
the hull so that the tube of the prop shaft is
protruding 25 mm out of the hull.
Before proceeding double check that the as-
sembly is placed in the centre of the hull.
Seite 5
©
Krick Modelltechnik Knittlingen
Advertisement
