Advertisement
Then glue these inner parts onto one outer
side (160) that a gap remains for the rudder
shaft.
Roughen well the rudder shaft on the area,
which will be glued into the rudder.
Now glue in the rudder shaft with Uhu Acrylit
and the second outer plate (160) on top.
Stand Juli 2014
Now make a profile on the rudder, sharp at the
end and round at the front.
6. Motor Mount
Make the motor mount / Servo tray assembly
from parts 16-17 and 18 and glue. You will find
on the laser sheets two different motor mounts.
First compare with the motor, which motor
mount is the correct one for your motor.
For 400 motors there are parts on sheet 2.For
500/600 motors on sheet 3.
Now make the battery and receiver tray with
parts 19, 20 and 21.
20 20
Seite 4
18
16
17
21
19
21
©
Krick Modelltechnik Knittlingen
Advertisement
