Advertisement
If you like to install the special features such as
- rotating radar
- Lighting
- And working fire monitor,
You will also need following items:
- Pump ( 65150)
- Mini lights
- Geared motor 1:300 (42203)
If you wish to install these items you will also
need a 4/6 radio control
Pictures in the following instruction should
help to make the building of the model as easy
as possible.
For identifying the laser cut parts in the
wooden sheets, there is a drawing at the end
of this instruction book. Before you start build-
ing you should identify all wooden parts and
mark the part nos. on the part with a soft pen-
cil. During the building process you should
carefully cut out the required parts only. Cut at
the tabs with a sharp knife.
Starting this hobby is much easier, if you have
an experienced modeller to call on. Often the
best way is to join a local model boat club.
We wish you good fun and success with build-
ing this nice model.
I. BOAT STAND and HULL
1. Boat stand
4
2
4
First build the boat stand with parts 2, 3 and 4.
After the glue is dry carefully sand and varnish
the stand several times. As you will later place
your wet model on the stand, it is important to
have this water resistant. To protect the model
you can use some pieces of foam tape on the
stand parts which will come in contact with the
hull.
Stand Juli 2014
2. Hull
Mark the positions of the rudder tube and of
the prop shaft on the hull (1). First measure the
centre line of the hull and mark. Then mark the
rudder tube position 35 mm from the stern of
the hull. Mark the position of the prop shaft 15
mm down from keel end.
Now drill the holes for prop shaft and rudder
tube.
First use a small drill of about 2 – 3 mm and
then enlarge to the correct size – rudder tube 4
3
mm and prop shaft tube 6 mm. You can do this
best with a round file to stop the hull from split-
ting.
3. Deck
Now fit the deck to the inside of the hull (5). At
the area of the bow it is necessary to chamfer
the deck so it is a snug fit and sits in the hull
without any pressure being applied.
Seite 2
1
5
chamfer in the front
area
©
Krick Modelltechnik Knittlingen
Advertisement
