Advertisement
156
150
14. GPS antenna
Make the GPS antenna from parts 149.1 to
149.5.
149.5
.4
.3
.2
.1
Glue the parts together concerning there size.
Then sand the glued parts round to a hemi-
sphere.
Stand Juli 2014
151
152
Seite 18
Stickers and letters
The letters are cut from weatherproof self ad-
hesive foil. Cut out the full word from the foil
and then tear off the rest material around the
letters. To leave the letters in exactly the same
distance to each other, when removing the
support material, glue some tape over the let-
ters, which you can tear off later. The letters do
not need to be covered 100%. It is advisable to
leave the upper or lower edges of the letters
free for exact positioning of the letters. Then
carefully tear off the support material and place
the letters exactly into place. Finally remove
the tape carefully from the letters.
Cut out the emblem exactly and glue it to each
side of the cabin.
IV. Installation of the pump
The pump to make the fire monitor working is
available as an extra accessory.
Drill a 4 mm hole into the hull directly behind
the propeller for adding the brass tube 159 and
glue this with Uhu Acrylit into the hull.
©
Krick Modelltechnik Knittlingen
149
Advertisement
