Advertisement
68
67
66
65
64
63
Chamfer the edges of parts 65 and 67 all
around.
67
Now glue parts 63 to 76 all together, aligned by
the hole in the centre.
67
65
63
The next step is to fit the brass tube into the
radar housing as a bearing for the radar shaft
with superglue or epoxi. At the top the brass
tube should protrude about half a millimetre.
Sand the rear edge of the radar bar 68 round.
Stand Juli 2014
Glue the radar shaft 70 into the bar with super-
glue.
65
If you wish to make the radar working, you also
have to do the following steps and order the
optional geared motor.
Make the motor mount from parts 72 and 73
and prepare the slot parts 74.
66
64
Fix the motor with screws to the motor mount.
Then fit the coupling tube 71 onto the shaft of
the motor.
69
Seite 12
Sand this edge round
72
74
©
Krick Modelltechnik Knittlingen
70
73
71
75
Advertisement
