Advertisement
Now place the deck into the hull and mark a
line on the sides 2 to 3 mm over deck level.
Cut the hull down only until to this line with a
sharp knife or strong scissors.
1
5
Now place strips (6 to 9) on the underside of
the deck around the inner cut out. Place a
weight on the deck until the glue is dry so the
deck cannot twist.
6
5
Now the coaming strips (10 to 13) have to be
glued vertical to the strips so that they are flush
on the underside and protruding on the upper
side. The superstructure will sit over this so
that no water can ingress the hull.
5
Stand Juli 2014
10 to 13
5
Seite 3
4. Rudder Tube
Glue the rudder tube (14 ) to the 2 supports
(15). Use medium or thick super glue or UHU
plus acrylit glue for this. Place the parts onto a
flat surface. Once dry place the assembly into
the hull along with the third support. Glue this
support to the rudder tube, but do not yet glue
into the hull.
15
5. Rudder
163
162
160
Make the rudder from parts 160 – 163. First
glue parts 162 and 161 to each other.
©
Krick Modelltechnik Knittlingen
14
161
Advertisement
