To Change The Camera Configuration From The Rv100 (Usb Or Wireless) To The Rv100 Pro - Welch Allyn RetinaVue 100 Imager Pro Directions For Use Manual

52 Enable the RetinaVue Network
•
To change the camera configuration from the RV100 (USB
or Wireless) to the RV100 Pro:
1. Touch Settings.
2. Touch Advanced settings.
3. Touch Camera configuration.
Note
4. Touch RV100 Pro to convert the RV100 to the RV100 Pro and to use the RetinaVue
100 Imager Pro camera with unencrypted images without using the RetinaVue
Network:
a. Touch OK at the prompt: Saved exams stored on this camera will be
b. At the RetinaVue 100 Imager camera set up screen, touch the RV100 Pro radio
For USB set up, touch the RetinaVue Network - USB radio button and see the
manual Software installation instructions for instructions on downloading the
RetinaVue Network software application onto your PC.
The RetinaVue 100 Imager Pro camera provide a means to
revert back to the RetinaVue 100 Imager Pro model at this
point in the configuration.
discarded.Note: This prompt only appears if saved exams have not been
transferred.
button to revert back the RetinaVue 100 Imager Pro model.
Welch Allyn RetinaVue™ 100 Imager Pro