Welch Allyn RetinaVue 100 Imager Pro Directions For Use Manual page 64

60 Viewing or changing the RetinaVue 100 Imager Pro settings
7. Use the touchscreen numeric keypad to enter an access code into the Access code
field and then retype the same code into the Access code (retype) field.
Note
Note
8. Touch OK to accept the code and touch OK again at the confirmation screen to
return to the Advanced Settings screen.
9. Touch
10. Touch
Reset the Advanced settings code
Note
1. Remove the RetinaVue 100 Imager Pro from the docking station charger.
2. If the RetinaVue 100 Imager Pro is set with a Device access code (in addition to the
Advanced settings code) and you are not already logged in, enter the existing Device
access code.
3. Touch Settings on the RetinaVue 100 Imager Pro Home screen.
4. Touch Advanced Settings.
5. Enter the existing Advanced settings code for the RetinaVue 100 Imager Pro.
6. Touch Advanced settings code.
7. Touch Reset to clear the existing Advanced settings codes.
8. Use the touchscreen numeric keypad to enter a code into the Advanced settings
code field and then retype the same code into the Advanced settings code (retype)
field.
The access code password can contain a minimum of 1-digit
and a maximum of 18-digits. Characters are only numeric
from 0 through 9.
Alternatively, after the code reset, touch
(Back), and (Home) to return to the RetinaVue 100
Imager Pro Home screen without using a Device access
code.
(Back) to return to the Settings screen.
(Home) to return to the RetinaVue 100 Imager Pro Home screen.
See the Troubleshooting section if you cannot recall your RetinaVue 100
Imager Pro Advanced settings code or the Device access code and need to
erase the code.
Welch Allyn RetinaVue™ 100 Imager Pro
(Back),