Transfer Patient Exams From The Retinavue 100 Imager Pro To A Computer - Welch Allyn RetinaVue 100 Imager Pro Directions For Use Manual

Directions for use
Transfer patient exams from the RetinaVue 100 Imager Pro
to a computer
1. Place the RetinaVue 100 Imager Pro into the cradle and ensure that the cradle is
connected to a computer by the USB cable.
2. Power on the computer and the RetinaVue 100 Imager Pro.
3. If using a computer on a network, enter your credentials.
Note
4. Within a few seconds, an Autoplay pop-up window appears on the computer screen,
indicating that a new storage volume (the RetinaVue 100 Imager Pro camera's SD
card) was detected.
5. Click on the storage volume. Click on the folder with the Patient ID that you created
previously on the RetinaVue 100 Imager Pro camera.
6. Double-click on the .jpg image to open an exam image in your installed photo viewer
program.
7. Select the image and copy the image and paste it into the desired location.
It is the responsibility of the health care provider to protect
patient health information and to meet regulatory and HIPAA
compliance. The images on the RetinaVue 100 Imager Pro
may contain identifiable patient information and it is the
responsibility of the health care provider to ensure that data
safeguards are implemented to protect patient health
information.
Using the RetinaVue 100 Imager Pro 39