Welch Allyn RetinaVue 100 Imager Pro Directions For Use Manual page 63

Directions for use
4. Touch Advanced Settings.
5. Touch Device Access Code to enter an access code for the RetinaVue 100 Imager
Pro.
6. Use the touchscreen numeric keypad to enter an access code into the Access code
field and then retype the same code into Access code (retype) field.
Note
7. Touch OK to accept the code and touch OK again at the confirmation screen to
return to the Advanced Settings screen.
8. Touch
9. Touch
Reset the Device access code
Note
1. Remove the RetinaVue 100 Imager Pro from the docking station charger.
2. If you are not already logged in, enter the existing access code for the RetinaVue 100
Imager Pro.
3. Touch Settings on the RetinaVue 100 Imager Pro Home screen.
4. Touch Advanced Settings.
5. Touch Device access code.
6. Touch Reset to clear the existing access codes.
The access code password can contain a minimum of 1-digit
and a maximum of 18-digits. Characters are only numeric
from 0 through 9.
(Back) to return to the Settings screen.
(Home) to return to the RetinaVue 100 Imager Pro Home screen.
See the Troubleshooting section if you cannot recall your RetinaVue 100
Imager Pro access code and need to erase the access code.
Viewing or changing the RetinaVue 100 Imager Pro settings 59