Dexter Laundry T-350 Parts & Service Manual page 48

Service Procedures
Clothes Door Removal
1. The clothes door may be removed from the hinge bracket by unscrewing and removing the allen-
head pivot screw located at the door upper hinge point.
2. Next lean the door out of the top of the hinge bracket and lift the door from the bottom hinge
pin.
NOTE:
the spacer between the bottom of the door and the hinge.
Clothes Door Latch Adjustment
1. Loosen the lock nut on the latching stud. It is located directly behind the door handle.
2. Open the loading door.
3. Screw the door catch stud in or out as necessary and then retighten the lock nut.
Door Switch Removal And Installation
1. Each door switch is located directly behind the hinge plate of the loading door assembly.
2. The entire switch can now be pulled from the front panel opening.
3. The switch has two clips that hold it in place on the rear of the switch.
4. With the panel removed, you can now squeeze the two clips and allow switch to be pushed back
through panel and grasped from the front and switch removed.
Installation Of Clothes Door Window And Gasket
1. Place the clothes door, with its face down, on a solid surface.
NOTE:
2. Install the window gasket on the clothes door flange. The wider lip of the gasket should be on the
bottom side or front face of the clothes door and the ridges should be up.
3. Locate the seam at the latching stud.
4. Apply a soapy water solution or rubber lubricant to the gasket.
5. Slide the glass into the middle of the door ring and gasket with half of the glass above the door
and half below.
6. While pressing down on the glass, stand the door up and use a modified screw driver with the
end rounded off to install half of the glass. Lay the door down and install the other half.
7. At the six o'clock position, pry the glass up enough to install the black spacer. (reuse from old
door gasket)
High Limit Thermostat Location And Function
A. Burner Housing
1. The thermostat opens the circuit to the main burners in the event of malfunction in the gas
control area or temperature control. This thermostat will open quickly if there is a significant loss
of air flow over the burner area.
2. It is covered by a guard and is held in place by two screws. There are spacers between the
thermostat and bracket which must be used to give proper operation.
48
Part # 8533-104-001 1/18
Prewarming the gasket makes the installation much easier.
- This hi-limit is located on the back side of the burner housing.