Wash Cycle Programming - Dexter Laundry T-350 Parts & Service Manual

0 to 15 minutes for Flush, Prewash, Rinse1 and Rinse 2, 3 to 15 minutes for Wash and Final Rinse.
For the baths that can, if the time is set to zero, then that bath will be eliminated from the cycle.
HH – hot, CH – warm, CC – cold, EE – no water. The owner can set the bath default. For the wash
bath, the default is over ridden for that cycle by the customer when the temperature is selected.
LO – low The owner can change the displayed value, but for a coinwasher only LO will be put into
the cycle.
The selections are "d" for delay the bath time until water level is reached or "t" for decrement bath
time during the fill.
0 to 10 minutes for Prewash, Wash, Rinse1 and Rinse 2,3,4. 1 to 10 minutes for Final Spin.
The owner can change the displayed value, but for a coin washer only 0 will be put into the cycle.
Washer 6 Default Cycles (Preset at Factory)
There are 6 pre programmed baths on the control which are set up at the factory. The
formulas for each are shown on the following pages. Each of these 6 programs can be
adjusted and saved as the owner needs.
30
Part # 8533-104-001 1/18
Bath Cycle Time "ct"
Bath Water Temperature "t"
Bath Water Level "L"
Bath Delay Fill "dF"
Bath Spin Time "S"
Bath "IS"